Schluter Kerdi Shower Pan



Kerdi Shower Tray

The Kerdi Shower Pan is made with a pre-pitched slope and is ready to be installed on to your substrate.  The tray comes in two pieces that are mortared together using a thin-set mortar.  The Kerdi Drain is made to fit the integrated inlet constructed into the tray with ease.

The Schluter Kerdi Shower Tray is pre-sloped and made of a lightweight, expanded polystyrene for constructing tiled shower assemblies.  It is designed to accept the Schluter Kerdi Drain and Schluter Kerdi waterproofing membrane. 

Kerdi Shower Tray
The tray is available in 48" x 48" (122 cm x 122 cm), 32" x 60" (81 cm x 152 cm), and 72" x 72" (183cm x 183 cm) sizes with centered drain placement, and the 32" x 60" (81 cm x 152 cm) with an off-center drain placement 10" (25.4 cm) from the end of the tray.

The Schluter tray is made of expanded polystyrene (EPS) foam with a high compressive strength (57 psi). It is serviceable in temperatures up to 175°F (79° C). The tray is extremely strong and will support the load of a typical tile shower install. In fact, the Schluter tray will support glass doors and glass block walls. This tray can be cut down or trimmed to fit any size shower. If trimming the tray, make sure that you are taking the same amounts off of each side. This will maintain the correct pitch and slope.

The Schluter Kerdi Tray can be installed using a 1/4" x 3/16" V-notched trowel.



Schluter Kerdi Shower Pan to Schluter Shower System

Follow us on Facebook

Follow us on Twitter

Featured Products: